AFLAS
®
>
FAQ
> processability
FAQ
There are replies to a selection of questions about fluoropolymers. Please click
here
if you have any other questions.
Q1. Molding method
Q2. Compounding
Q3. Shrinkage on compression molding
Depending on the formulation, the shrinkage is about the same as FKM and in the range from 2.5 to 3.0 %.
Q4. Mold release
(C)Copyright ASAHI GLASS CO., LTD. 2005-2007. All Rights Reserved.
Privacy Policy
AFLAS® > FAQ > processability
(C)Copyright ASAHI GLASS CO., LTD. 2005-2007. All Rights Reserved. 
