AFLAS
®
>
FAQ
> processability
FAQ
There are replies to a selection of questions about fluoropolymers. Please click
here
if you have any other questions.
Q1. Molding method
Q2. Compounding
Sodium stearate should be dispersed well into compound, otherwise it may be a cause of bubbling.
Q3. Shrinkage on compression molding
Q4. Mold release
(C)Copyright ASAHI GLASS CO., LTD. 2005-2007. All Rights Reserved.
Privacy Policy
AFLAS® > FAQ > processability
(C)Copyright ASAHI GLASS CO., LTD. 2005-2007. All Rights Reserved. 
